Bresser Solarix Az Telescope 114/500 with Solar Filter: A Practical Guide (2026)
Learn how to set up the bresser solarix az telescope 114/500 with solar filter for safe sun viewing, with steps, safety checks and common mistakes to avoid.
Updated November 2026
The Bresser Solarix AZ 114/500 with solar filter is a beginner-friendly reflector that lets families safely watch sunspots, solar limb features and partial eclipses. This guide walks you through checking the included filter, mounting the scope, aiming it at the Sun without looking through it, and getting a sharp focus. You will also learn the habits that keep young observers safe every time.
What the Bresser Solarix AZ 114/500 Is Good For
The Solarix AZ 114/500 is a 114 mm (4.5-inch) reflector telescope with a 500 mm focal length, mounted on a simple altazimuth mount. The “AZ” means it moves up-and-down and side-to-side, which is the most intuitive motion for kids. The “solar filter” in the name refers to a full-aperture filter that fits over the front of the tube and blocks nearly all sunlight before it enters the optics.
Shopping for one? See our guide: 3 Best Solar Filter Materials for Telescope Viewing in 2026.
With that filter in place, the scope can show sunspot groups, the granulated texture of the photosphere and sometimes prominences near the limb. It is also useful for partial solar eclipses, where kids can watch the Moon slide across the Sun. Manufacturers list the aperture and focal length in the product specifications, and those numbers are what determine how much detail you can see, so check them against the box before you go outside.
Before You Start: Safety Rules for Solar Viewing
Sunlight is intense enough to cause permanent eye damage in seconds, and a telescope concentrates that light. Never look at the Sun through the telescope’s eyepiece, through a finderscope, or with your unaided eyes unless you are using a certified filter designed for that purpose. Never use a solar filter that is cracked, scratched, wrinkled or held on with tape.
Adults should check the filter before every session. If you are unsure whether a filter is safe, stop and consult an experienced astronomy club or an optics professional before observing.
Safety Checklist
- Inspect the front filter for pinholes, tears, creases or peeling edges in daylight, and replace it if anything looks damaged.
- Confirm the filter is firmly seated over the front of the tube with no gaps.
- Cover the finderscope or remove it completely so no one looks through it at the Sun.
- Never place the eyepiece or any part of the scope in direct sun without the front filter installed.
- Keep children under direct supervision at all times while the scope is aimed at the Sun.
- Do not let anyone look through the eyepiece with the filter removed, even briefly.
What You Need Before Setup
Gather everything before you bring the telescope outside. A simple table helps everyone in the family know what is needed.
| Item | Purpose |
|---|---|
| Bresser Solarix AZ 114/500 with included solar filter | Main telescope and safe sun-viewing filter |
| Eyepieces supplied with the scope | Set magnification for viewing |
| Flat, stable surface or sturdy tripod | Keeps the scope steady during observing |
| Hand towel or lens cloth | Cleans the eyepiece and filter edges |
| Sun-safe notebook and pencil | Records sunspot counts and observations |
| Sunscreen and hat | Protects the observer during daytime sessions |
Step-by-Step Setup Guide
Step 1: Assemble the Mount and Tube
Attach the tube to the altazimuth mount using the mounting ring or dovetail bar included with the scope. Tighten the clamp screws by hand until the tube feels secure, then check that it can move freely up and down. Set the mount on level ground. A wobbling tripod makes focusing very frustrating, especially on fine solar detail.
Step 2: Install the Solar Filter
Before you touch the eyepiece, slide the solar filter over the front of the optical tube. Press it on firmly so it sits flush, and make sure there are no gaps around the edge. Run your fingers around the rim to confirm it is seated evenly. Do not use any other front-mounted filter in place of the solar filter.
Step 3: Aim the Scope Without Looking Through It
Aim the telescope using its shadow. Move the tube until the shadow it casts on the ground is as small as possible, which means the tube is roughly pointed at the Sun. Then use the altazimuth controls to fine-tune the position while watching the sunlight that comes through the front of the scope. A safe alternative is a solar projection board: point the scope, hold a white card behind the eyepiece, and watch the projected image of the Sun. Only experienced adults should attempt the projection method.
Step 4: Insert the Eyepiece and Set Magnification
Once the Sun is centered in the view, insert a low-power eyepiece, which gives a wide field and is easiest to aim. Magnification depends on the eyepiece focal length. Divide the telescope’s 500 mm focal length by the eyepiece’s focal length in millimeters to get the power. For example, a 20 mm eyepiece gives about 25x. Start with the lowest power you have, since the Sun is easier to find and track at lower magnification.
Step 5: Focus Carefully
Turn the focuser knob slowly until the solar disk looks sharp. Small movements make a big difference, so work in tiny steps. Once the image is crisp, you may see sunspots as dark patches and fine granulation across the surface. If the image shimmers, wait a few minutes; air turbulence is common on warm days.
Step 6: Track and Observe
The Sun moves across the sky, so the image will drift out of view. Use the altazimuth handles to nudge the tube gently and keep the Sun centered. Limit each session to short periods, and let the scope and observer rest between sessions.
Step 7: Record Your Observations
Sketch what you see with the date, time and magnification. Count sunspots if you notice them. Over several days, kids can compare how spots move across the disk as the Sun rotates, which turns a quick look into a real science activity.
Common Mistakes to Avoid
- Using a damaged filter. Even a tiny pinhole can cause eye injury. Inspect the filter before every session.
- Leaving the scope unattended. Children may look through the eyepiece or finderscope when adults step away.
- Aiming with the finderscope. Remove or cover the finderscope before observing, since its concentrated light can harm eyes.
- Using high power too early. High magnification makes the Sun harder to find and more affected by heat shimmer.
- Forgetting the filter after cleaning. Reattach the solar filter every time you put the scope back together.
- Observing for too long. Heat can build up in the tube and mount, and young observers tire quickly.
Tips for Family Solar Sessions
Plan observing for mid-morning or mid-afternoon, when the Sun is well above the horizon and the air is often steadier than at midday. Set up in shade nearby so the observers can rest between looks. Make the session a routine: check the filter, sketch what you see, and talk about what the spots might be. Kids who help with setup tend to take the safety rules more seriously, so give them a checklist role.
Before major events, read the official observing guidance from reputable astronomy organizations, and check the official site for current event timing details. Partial eclipses are rare enough that many families plan around them well in advance.
Recommended gear
A few accessories make solar viewing easier and safer for families.
- Solar filter film for telescope use. Replacement filter film can be useful if the included filter ever becomes damaged, though you should only use material designed specifically for solar observing. View on Amazon
- Lens cleaning cloth. A soft microfiber cloth helps keep eyepiece lenses dust-free without scratching the glass. View on Amazon
- Sturdy tripod for small reflectors. A stable tripod keeps the tube steady during long sun-watching sessions. View on Amazon
- Astronomy observing journal. A simple logbook helps kids record sunspot sketches and dates for comparison. View on Amazon
Further Reading
If you are comparing other options, see Top 5 Telescope Filters for Solar Eclipse Picks for Safe Viewing and Solar Filter for Skywatcher Telescope: 6 Best Picks Compared (2026). For the filter material itself, Telescope Solar Filter Film: How to Choose and Use It Safely (2026) explains what to look for. Families with a different tube size may find Solar Filter 8 Inch Telescope: How to Choose and Use One Safely (2026) useful. If you are considering a wider filter lineup, Telescope Filter Buying Guide: 7 Best Picks Compared (2026) offers a good overview.
FAQ
Can I look at the Sun through the Bresser Solarix AZ 114/500 with the solar filter on?
Yes, but only through the telescope with the solar filter firmly installed over the front of the tube and no damage to the filter. Never look at the Sun through the finderscope or with your unaided eyes.
How do I know if the solar filter is damaged?
Hold it up to a bright light source in daylight and look for pinholes, tears, creases, wrinkles or peeling edges. If you see any damage, replace the filter before observing.
What eyepiece should I start with for solar viewing?
Begin with the lowest-power eyepiece you have. Lower magnification makes the Sun easier to find, aim and keep centered, and it reduces the effect of heat shimmer.
Why does the image of the Sun look blurry?
Blurriness is often caused by air turbulence, a slightly out-of-focus image, or a loose mount. Make small focus adjustments, tighten the clamps, and wait for steadier air if the image keeps shimmering.
How long can kids safely observe the Sun in one session?
Keep sessions short and supervised. Give everyone regular breaks, check the filter often, and avoid letting the telescope heat up for long periods. Adult guidance is essential for children at all times.
Can I use this telescope for other sky objects?
Yes, the telescope works well for the Moon, planets and bright deep-sky objects at night. Remove the solar filter before any nighttime observing, since it blocks almost all light and will not let you see faint objects.
What should I do if someone looks at the Sun without a filter?
Stop the session right away and seek medical attention from an eye care professional if there is any pain, blurring or vision change. Do not wait for symptoms to appear.
Conclusion
With a careful check of the solar filter, a stable mount and a steady routine, the Bresser Solarix AZ 114/500 with solar filter can give families a safe view of sunspots and partial eclipses. Treat every session as a safety check first and a sky-watching activity second. Keep notes, compare observations over several days, and let young observers help with each step.
Related reading
- Top 5 Telescope Filters for Solar Eclipse Picks for Safe Viewing
- Top 5 Solar Filters for 12 Inch Telescope Picks for Safe Sun Viewing
- Top 5 Glass Telescope Solar Filter Options for Safe Sun Viewing
- Telescope Without Solar Filter: 5 Best Options Compared (2026)
- Telescope Solar Filter Film: How to Choose and Use It Safely (2026)
Ready to choose one?
